Configuring the Stack 89
setting is the IP and SLIP information, which is retained to ensure that you
can continue managing the stack. You may want to initialize the stack if it
has previously been used in a different part of your network, and its
settings are incorrect for the new environment.
CAUTION:
Use great care when initializing the stack — it removes all
configuration information, including password and security information.
CAUTION:
When initializing the stack, network loops may occur if you
have set up port trunks, resilient links, VLANs, or the Spanning Tree
Protocol. Before initializing the stack, ensure you have disconnected the
cabling for all standby or duplicate links.
The stack takes about 10 seconds to initialize. While the stack is
initializing, you cannot communicate with it.
Upgrading
Management
Software
You can upgrade the management software of all Switch units in the
stack using the Software Upgrade page.
To access the page:
1
Click the
Configuration
icon on the side-bar.
2
Click the
Software Upgrade
hotlink. The Software Upgrade page is
displayed as shown in Figure 24
.
Figure 24
The Software Upgrade page
To Next Page
Loading...
Need help?
General