3Com SuperStack II - X.21 DTE Cable Pinouts

52 C
HAPTER
3: W
ORKING
W
ITH THE
W
EB
I
NTERFACE
■
Roving Analysis Setup
— This page allows you to set up roving
analysis ports for the stack.
■
Resilient Links
— This page allows you to set up resilient links for
the stack.
■
Reset
— This page allows you to reset the Switch units in the
stack.
■
Port Trunks Setup
— This page allows you to set up port trunks
for the stack.
■
Initialize
— This page allows you to initialize the Switch units in
the stack.
■
Advanced Stack Setup
— This page allows you to configure the
advanced settings of the stack.
For more information, see “Configuring the Stack”
on page 71.
■
Health Pages
— These pages allow you to display statistics for the
current Switch in the stack:
■
Unit Graph
— This page allows you to display a range of statistics
for all the ports on the Switch.
■
Port Graph
— This page allows you to display a range of statistics
for a specific port on the Switch.
For more information, see “Displaying Statistics for the Current
Switch” on page 91.
Navigating the Page Area
To access the first page of each category, click on the relevant
Management Icon on the side-bar; to access the remaining pages in the
category, click on the underlined hotlinks that are displayed at the top of
each page.
There are four exceptions to the navigation system. The Color Key page,
Port Summary page, Port Setup page and Console Port Configuration
page are accessed from the Switch Graphic page.
Figure 5
shows you how to access each of the web pages.