Displaying and Changing System Feature Information 131
Removing a Resilient
Link
You can remove resilient links from the Switch units within the stack
using the
remove
command on the Resilience menu.
To remove a resilient link:
1
At the Top-level menu, enter:
feature resilience remove
The following prompt is displayed:
Select resilient link index (1,2):
2
Enter the resilient link index number for the resilient link that you wish to
remove.
Swapping over Active
Links
You can swap over the resilient links on the Switch units within the stack
to redesignate the active link by using the
swap
command on the
Resilience menu.
To swap over the active link:
1
At the Top-level menu, enter:
feature resilience swap
The following prompt is displayed:
Select resilient link index (1,2):
2
Enter the resilient link index number for the resilient link that you wish to
become active.
Adding a Port to a
Trunk
You can add a single port to a trunk on the current Switch unit using the
addPort
command on the Trunk menu.
To add a port to a trunk:
1
At the Top-level menu, enter:
feature trunk addPort
The following prompt is displayed:
Select trunk index (1-2):
2
Enter the index number of the trunk that you wish to add a port to.
The following prompt is displayed:
Enter ports (1,2,7):
To Next Page
Loading...
