Displaying and Changing SNMP-related Information 139
Removing Trap
Destination Details
You can remove the details of a current trap destination device using the
remove
command on the SNMP/Trap menu.
To remove trap destination details:
1
At the Top-level menu, enter:
snmp trap remove
The following prompt is displayed:
Select trap index (1,2,3,all):
2
Enter the index number of the trap destination device that is to have its
details removed, or enter
all
to remove all trap destination device
details.
Performing an SNMP
GET Command
An SNMP GET command allows you to retrieve values of SNMP objects
from a network device. You can perform an SNMP GET command on the
stack using the
get
command on the SNMP menu.
To perform an SNMP GET command on the stack:
1
At the Top-level menu, enter:
snmp get
The following prompt is displayed:
Enter object-identifier:
2
Enter the identifier of the SNMP object.
The following prompt is displayed:
Enter type (phys,ip,gauge,cnt,num,str)[str]:
3
Enter the data type of the SNMP object.
The value of the SNMP object is displayed.
Performing an SNMP
GETNEXT Command
An SNMP GET NEXT command allows you to specify an SNMP object in a
network device and then retrieve information about the next few SNMP
objects in the device. You can perform an SNMP GET NEXT command on
the stack using the
next
command on the SNMP menu.
To perform an SNMP GETNEXT command on the stack:
1
At the Top-level menu, enter:
snmp next
To Next Page
Loading...
