3Com SuperStack II - Technical Support; Online Technical Services

Configuring the Stack 81
3
Click the
Next...
button.
4
From the
Main Link
field, select the main port of the resilient link pair.
5
Click the
Next...
button.
6
From the
Standby Link
field, select the standby port of the resilient link
pair.
7
Click the
Next...
button. The Resilient Links page is displayed showing the
new resilient link pair.
Deleting a Resilient Link Pair
The Resilient Links page allows you to delete a resilient link pair. To do
this:
1
Click the resilient link pair.
2
Click the
Delete
button.
Swapping the Active Port of a Resilient Link Pair
The Resilient Links page allows you to swap the active (or enabled) port of
a resilient link pair. To do this:
1
Click the resilient link pair.
2
Click the
Swap
button.
Setting Up Port
Trunks
You can set up port trunks for the stack using the Port Trunk Setup page.
To access the page:
1
Click the
Configuration
icon on the side-bar.
2
Click the
Port Trunks
hotlink. The Port Trunks Setup page is displayed as
shown in Figure 21
.