3Com SuperStack II - Displaying MAC Addresses for a Port; Removing MAC Addresses from a Port; Displaying Port Information

Displaying and Changing Bridging/VLANs Information 111
Displaying MAC
Addresses for a Port
You can display a list of MAC addresses associated with a selected port
using the
list
command on the Address menu.
To display a list of MAC addresses:
1
At the Top-level menu, enter:
bridge port address list
The following prompt is displayed:
Select bridge ports (1-12, all):
2
Enter the number of the port that you wish to have its associated MAC
addresses displayed, or enter
all
for all the ports.
The command produces a list of all MAC addresses associated with the
specified port(s).
Removing MAC
Addresses from a Port
You can remove a MAC address associated with a selected port using the
remove
command on the Address menu.
To remove a MAC address:
1
At the Top-level menu, enter:
bridge port address remove
The following prompt is displayed:
Enter the address to be removed:
2
Enter the address that you wish to remove. The address must be entered
in the form of hyphen separated bytes, for example: 08-00-02-06-03-bd.
The following prompt is displayed:
Enter the VLAN ID for this address (1-4094) [1]:
3
Enter the VLAN ID for the address that you wish to remove.
Displaying Port
Information
You can display information about a port on the current Switch unit using
the
detail
command on the Port menu.
To display the port information:
1
At the Top-level menu, enter:
bridge port detail
The following prompt is displayed:
Select bridge port (1-12):