Agilent Technologies 4155C Command Reference

5-54 Agilent 4155C/4156C SCPI Command Reference, Edition 1
SCPI Commands
:HCOPy:PAGE:DIMensions:LLEFt
:HCOPy:PAGE:DIMensions:LLEFt
This command sets the lower left corner of the output region.
At *RST, the value of this parameter is (0,0).
Syntax :HCOPy:PAGE:DIMensions:LLEFt x | MINimum | MAXimum,
y | MINimum | MAXimum
Parameter
Query response x, y <newline><^END>
The data type of x and y are NR3 response data.
Example OUTPUT @Hp4155;":HCOP:PAGE:DIM:LLEF 10,90"
OUTPUT @Hp4155;":HCOP:PAGE:DIM:LLEF?"
ENTER @Hp4155;A,B
:HCOPy:PAGE:DIMensions:QUADrant<n>
This command sets LOWER LEFT and UPPER RIGHT so that the setup data is
printed on the upper right quarter, upper left quarter, lower left quarter, or lower
right quarter of the page.
A numeric suffix is required to specify the quadrant.
This command defines an event and thus has no *RST state or query form.
Parameter Type Explanation
x numeric percentage from the left side of the paper
y numeric percentage from the bottom of the paper
<n> quadrant
1 upper right quarter
2 upper left quarter
3 lower left quarter
4 lower right quarter

Agilent Technologies 4155C Specifications

General

Brand	Agilent Technologies
Model	4155C
Category	Measuring Instruments
Language	English