To Next Page

To Previous Page

5-270 Agilent 4155C/4156C SCPI Command Reference, Edition 1

SCPI Commands

:PAGE:STRess:SETup:HTIMe

This command sets the hold time to wait between the non-synchronous (non-stress)

channel output and the synchronous channel (stress) output.

At *RST, this value is 0.

Syntax :PAGE:STRess:SETup:HTIMe hold_time | MINimum | MAXimum

Parameter

Query response hold_time <newline><^END>

hold_time is NR3 response data type.

Example OUTPUT @Hp4155;":PAGE:STR:SET:HTIM 0.5"

OUTPUT @Hp4155;":PAGE:STR:SET:HTIM MAX"

OUTPUT @Hp4155;":PAGE:STR:SET:HTIM?"

ENTER @Hp4155;A

OUTPUT @Hp4155;":PAGE:STR:SET:HTIM? MAX"

ENTER Hp4155;A

:PAGE:STRess:SETup[:MENU]

This command changes the present display page to STRESS: STRESS SETUP.

This command does not have query form.

Syntax :PAGE:STRess:SETup [ :MENU]

Example OUTPUT @Hp4155;":PAGE:STR:SET"

:PAGE:STRess:SETup:MODE

This command selects the stress mode.

If no PGU is set to VPULse mode, stress mode must be set to DURation.

At *RST, this value is DURation.

Syntax :PAGE:STRess:SETup:MODE DURation | PCOunt

Parameter Type Explanation

hold_time numeric 0 to 655.35 (s)

Agilent Technologies 4155C Command Reference

Other manuals for Agilent Technologies 4155C