Agilent Technologies 4155C

Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-181
SCPI Commands
:PAGE:MEASure:PGUSetup:PULSe:PGU<n>:DELay
:PAGE:MEASure:PGUSetup:PULSe:PGU<n>:DELay
This command sets the DELAY TIME of PGU<n>.
<n> is required to specify PGU number. Valid PGU numbers are PGU1 through
PGU2.
You use this command only if the specified PGU is set to VPULse mode (not V) by
the :PAGE:CHAN:PGU<n>:MODE command.
At *RST, this value is 0.
Syntax :PAGE:MEASure:PGUSetup:PULSe:PGU<n>:DELay delay_time | MINimum |
MAXimum
Parameter
Query response delay_time <newline><^END>
delay_time is NR3 response data type.
Example OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:DEL 1"
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:DEL MAX"
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:DEL?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:DEL? MAX"
ENTER @Hp4155;A
Parameter Type Explanation
delay_time numeric 0 to 10 (s)