Agilent Technologies 4155C Command Reference

Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-307
SCPI Commands
:SYSTem:COMMunicate:NETwork:FILEr:SET
:SYSTem:COMMunicate:NETwork:FILEr:SET
This command is one of the commands to register the network drive setup. To
register a setup, the following commands must be entered:
• :SYSTem:COMMunicate:NETwork:FILEr:NET:NAME
• :SYSTem:COMMunicate:NETwork:FILEr:NET:IPADdress
• :SYSTem:COMMunicate:NETwork:FILEr:NET:DIRectory
• :SYSTem:COMMunicate:NETwork:FILEr:SET
You can register maximum 4 setups.
This command registers the network drive setup. The setup data is stored in the
internal memory. Query returns the present setting.
Syntax :SYSTem:COMMunicate:NETwork:FILEr:SET NET1 | NET2 | NET3 | NET4
Parameter
Query response name, ipaddress, directory <newline><^END>
Example OUTPUT @Hp4155;":SYST:COMM:NET:FILE:SET NET1"
OUTPUT @Hp4155;":SYST:COMM:NET:FILE:SET? NET2"
ENTER @Hp4155;A$
See also :SYSTem:COMMunicate:NETwork:FILEr:DELete
Parameter Type Explanation
NET1 character Specifies register 1 to store the setup.
NET2 character Specifies register 2 to store the setup.
NET3 character Specifies register 3 to store the setup.
NET4 character Specifies register 4 to store the setup.

Agilent Technologies 4155C Specifications

General

Brand	Agilent Technologies
Model	4155C
Category	Measuring Instruments
Language	English