Agilent Technologies 4155C Command Reference

5-220 Agilent 4155C/4156C SCPI Command Reference, Edition 1
SCPI Commands
:PAGE:MEASure[:SWEep]:CONStant:SMU<n>[:SOURce]
:PAGE:MEASure[:SWEep]:CONStant:SMU<n>[:SOU
Rce]
This command sets the constant SOURCE value of SMU<n> for the sweep
measurement.
<n> is required to specify SMU number. Valid SMU numbers are SMU1 through
SMU6, depending on the configuration.
You use this command only if the function of the specified SMU is CONStant and
the mode is not COMMon.
At *RST, this value is 0 V.
Syntax :PAGE:MEASure [ :SWEep] :CONStant:SMU<n>[ :SOURce] source | MINimum |
MAXimum
Parameter
Query response source <newline><^END>
source is NR3 response data type.
Example OUTPUT @Hp4155;":PAGE:MEAS:CONS:SMU1 10"
OUTPUT @Hp4155;":PAGE:MEAS:CONS:SMU1 MAX"
OUTPUT @Hp4155;":PAGE:MEAS:CONS:SMU1?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:MEAS:CONS:SMU1? MAX"
ENTER @Hp4155;A
Parameter Type Explanation
source numeric -200 to 200 V or -1 to 1 A. The range of this value
depends on the type of SMU.

Agilent Technologies 4155C Specifications

General

Brand	Agilent Technologies
Model	4155C
Category	Measuring Instruments
Language	English