5-236 Agilent 4155C/4156C SCPI Command Reference, Edition 1
SCPI Commands
:PAGE:MEASure[:SWEep]:VARD:COMPliance
:PAGE:MEASure[:SWEep]:VARD:COMPliance
This command sets the COMPLIANCE value of VAR1'.
If the unit type of VAR1' is VSU, this parameter is ignored.
You use this command only if there is an SMU whose function (FCTN) is VAR1'.
Syntax :PAGE:MEASure [ :SWEep] :VARD:COMPliance compliance | MINimum |
MAXimum
Parameter
Query response compliance <newline><^END>
compliance is NR3 response data type.
Example OUTPUT @Hp4155;":PAGE:MEAS:VARD:COMP 2"
OUTPUT @Hp4155;":PAGE:MEAS:VARD:COMP MAX"
OUTPUT @Hp4155;":PAGE:MEAS:VARD:COMP?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:MEAS:VARD:COMP? MAX"
ENTER @Hp4155;A
Parameter Type Explanation
compliance numeric -200 to 200 V or -1 to 1 A. The range of this value
depends on SMU type of VAR1'.
To Next Page
Loading...
