Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-309
SCPI Commands
:SYSTem:COMMunicate:NETwork:PRINter:NET:GRAPhoption
:SYSTem:COMMunicate:NETwork:PRINter:NET:GR
APhoption
This command is one of the commands to register the network printer setup. To
register a printer setup, the following commands must be entered:
• :SYSTem:COMMunicate:NETwork:PRINter:NET:NAME
• :SYSTem:COMMunicate:NETwork:PRINter:NET:IPADdress
• :SYSTem:COMMunicate:NETwork:PRINter:NET:TEXToption
• :SYSTem:COMMunicate:NETwork:PRINter:NET:GRAPhoption
• :SYSTem:COMMunicate:NETwork:PRINter:NET:TYPE
• :SYSTem:COMMunicate:NETwork:PRINter:SET
You can register maximum 4 setups.
This command sets the graphic output option of lpr command which is sent to the
remote printer via your print server.
If you do not enter the :SYST:COMM:NET:PRIN:SET command, *RST clears this
setting. Query returns the present setting.
Syntax :SYSTem:COMMunicate:NETwork:PRINter:NET:GRAPhoption option
Parameter
Query response option <newline><^END>
Example OUTPUT @Hp4155;":SYST:COMM:NET:PRIN:NET:GRAP '-h-l'"
OUTPUT @Hp4155;":SYST:COMM:NET:PRIN:NET:GRAP?"
ENTER @Hp4155;A$
Parameter Type Explanation
option string graphic output option of lpr command.
To Next Page
Loading...
