Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-67
SCPI Commands
:MMEMory:DESTination
:MMEMory:DESTination
This command sets either the built-in flexible disk drive or the file system on your
NFS server as the mass storage device. You must enter this command before doing
file operation.
This command has no *RST state. This command also has a query form.
Execution
Conditions
To use the file system on your NFS server, do one of below. The :MMEM:DEST
command makes the NFS mount immediately.
Set the 4155C/4156C network setup and network drive setup on the SYSTEM:
MISCELLANEOUS screen.
Enter the commands of the :SYST:COMM:NET:SELF group and the following
commands to set the 4155C/4156C network setup and network drive setup:
• :SYST:COMM:NET:FILE:NET:NAME
• :SYST:COMM:NET:FILE:NET:IPAD
• :SYST:COMM:NET:FILE:NET:DIR
• :SYST:COMM:NET:FILE:SET
Syntax :MMEMory:DESTination INTernal | NET1 | NET2 | NET3 | NET4
:MMEMory:DESTination?
Parameter See Table 5-1.
Query response INT | NET1 | NET2 | NET3 | NET4 <newline><^END>
Example OUTPUT @Hp4155;":MMEM:DEST NET3"
OUTPUT @Hp4155;":MMEM:DEST?”
ENTER @Hp4155;A$
See also :SYSTem:COMMunicate:NETwork[:SELF]
:SYSTem:COMMunicate:NETwork:FILE:NET
:SYSTem:COMMunicate:NETwork:FILE:SET
To Next Page
Loading...
Need help?
General
