Agilent 4155C/4156C SCPI Command Reference, Edition 1 5-203
SCPI Commands
:PAGE:MEASure:QSCV:VAR1:MODE
:PAGE:MEASure:QSCV:VAR1:MODE
This command sets the VAR1 sweep mode for Quasi-static CV measurements. This
command also has a query form.
At *RST, this value is set to SING
Syntax :PAGE:MEASure:QSCV:VAR1:MODE SINGle | DOUBle
:PAGE:MEASure:QSCV:VAR1:MODE?
Parameter
Query response SING | DOUB <newline><^END>
Example OUTPUT @Hp4155;":PAGE:MEAS:QSCV:VAR1:MODE SING"
OUTPUT @Hp4155;":PAGE:MEAS:QSCV:VAR1:MODE?"
ENTER @Hp4155;A$
Parameter Type Explanation
SINGle character Single mode (start to stop)
DOUBle character Double mode (start to stop to start)
To Next Page
Loading...
