Chapter 3 87
Basic Operation
Using the Web Server
5. Enter the IP address of the signal generator in the web browser address field. For example,
http://101.101.101.101. Replace 101.101.101.101 with your signal generator’s IP address. Press the
Enter key on the computer’s keyboard.
NOTE The IP (Internet Protocol) address can change depending on your LAN configuration.
Use the
LAN Config Manual DHCP softkey to select a Manual or DHCP (dynamic host
communication protocol) LAN configuration. Refer to E4428C/38C ESG Signal Generator
Key and Data Field Reference for more information.
6. Press the enter key on the computer’s keyboard. The web browser will display the signal generator’s
homepage as shown below in Figure 3-7. This web page displays information about the signal generator
and provides access to Agilent’s website.
Figure 3-7 Signal Generator Web Page
To Next Page
Loading...
