Akai MPC 4000

Effect mode
142
DELAY>MULTITAP
This is a delay that lets you produce special effects by adjusting the spacing of the feed-
back sounds and the volume change curve of the feedback sound.
DELAY>PANNING
This delay effect moves the panning of the effect sound from left → center → right (LCR)
or right
→ center → left (RCL).
DELAY>PINGPONG
This delay effect alternately pans the delay sound to left or right.
Parameter Range Function
Delay 1–127 Adjusts the delay time.
Width 2–15 Adjusts the left/right spread of the feedback sound.
Shape –10–+10 Adjusts the spacing of the feedback sounds.
Slope –10–+10 Adjusts the decay curve of the feedback sounds.
Feedback 0–127 Adjusts the amount of feedback.
Pan –10–+10 Adjusts the panning of the effect sound.
Wet/Dry 100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect ON/OFF Switches the effect on/off.
Parameter Range Function
Delay 1ms–1500ms Adjusts the delay time.
Feedback 0–127 Adjusts the amount of delay feedback.
HFdamp 20Hz–20kHz
Adjusts the frequency at which the high-frequency range of the
feedback sound will be cut.
Mode LCR/RCL Specifies the panning effect.
Width 0–127 Adjusts the width of panning.
Wet/Dry 100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect ON/OFF Switches the effect on/off.
Parameter Range Function
Delay 1ms–1500ms Adjusts the delay time.
Feedback 0–127 Adjusts the amount of delay feedback.
HFdamp 20Hz–20kHz
Adjusts the frequency at which the high-frequency range of the
feedback sound will be cut.
Width 0–127 Adjusts the width of panning.
Wet/Dry 100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect ON/OFF Switches the effect on/off.
0–10 +10
0–10 +10
Shape
Slope
Original sound Delay sound