Akai MPC 4000

Edit page
143
DELAY>STEREO
This is a stereo delay in which left and right channels can be set independently.
DELAY>XOVER (Delay > Crossover)
This is a variation of a stereo delay. The difference is that the feedback of the L and R
channels is returned to the opposite channel.
DIGITAL EQ
This is a three-band parametric EQ.
Parameter Range Function
LDelay 1ms–1500ms Adjusts the L channel delay time.
Feedback 0–127 Adjusts the amount of feedback for the L channel delay.
HFdamp 20Hz–20kHz
Adjusts the frequency at which the high-frequency range of the
L channel feedback sound will be cut.
RDelay 1ms–1500ms Adjusts the R channel delay time.
Feedback 0–127 Adjusts the amount of feedback for the R channel delay.
HFdamp 20Hz–20kHz
Adjusts the frequency at which the high-frequency range of the
R channel feedback sound will be cut.
Wet/Dry 100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect ON/OFF Switches the effect on/off.
Parameter Range Function
LDelay 1ms–1500ms Adjusts the L channel delay time.
Feedback 0–127 Adjusts the amount of feedback for the L and R channel delay.
HFdamp 20Hz–20kHz
Adjusts the frequency at which the high-frequency range of the
L and R channel feedback sound will be cut.
RDelay 1ms–1500ms Adjusts the R channel delay time.
Width 0–127 Adjusts the stereo spread.
Wet/Dry 100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect ON/OFF Switches the effect on/off.
Parameter Range Function
1 Frequency 20Hz–20kHz Adjusts the center frequency of EQ1.
Gain –18dB–+18dB Adjusts the gain of EQ1.
Q 0.5–10 Specifies the Q of EQ1.
2 Frequency 20Hz–20kHz Adjusts the center frequency of EQ2.
Gain –18dB–+18dB Adjusts the gain of EQ2.
Q 0.5–10 Specifies the Q of EQ2.
3 Frequency 20Hz–20kHz Adjusts the center frequency of EQ3.
Gain –18dB–+18dB Adjusts the gain of EQ3.
Q 0.5–10 Specifies the Q of EQ3.
Output –60dB–+24dB Adjusts the output level of the effect sound.
Wet/Dry 100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect ON/OFF Switches the effect on/off.