Effect mode
144
DISTORTION
This is a monaural distortion effect that distorts the input signal. An EQ for shaping the
tone is connected in series.
ENHANCER
This is a monaural effect that adds new overtones to the signal, making the sound more
crisp.
EXPANDER
This is a monaural effect that expands the dynamic range by compressing the signal when
it falls below a specified level (threshold). This is the opposite effect from a compressor.
FLANGER>MONO
This is a conventional flanger effect. The effect itself is mono-in/mono-out, but you can
adjust the panning of the effect sound if you are playing back in stereo.
Parameter Range Function
Depth
0–31 Adjusts the amount of distortion.
EQ
frequency
0–127 Adjusts the center frequency of the EQ.
EQ
Gain
–15dB–+15dB Adjusts the gain of the EQ.
EQ Q
0.5–10 Adjusts the Q of the EQ.
Wet/Dry
100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect
ON/OFF Switches the effect on/off.
Parameter Range Function
Drive
0dB–30dB
Adjusts the gain of the signal that is input to the harmonic gen-
erator.
Tune
0–127 Adjusts the cutoff frequency of the filter.
Damp
0–127 Adjusts the filter decay curve (slope).
Harmonics
0–127 Adjusts the signal level of the boosted harmonics.
Wet/Dry
100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect
ON/OFF Switches the effect on/off.
Parameter Range Function
Threshold
–60dB–0dB Adjusts the threshold of the expander.
Ratio
2:1–100:1 Adjusts the compression ratio of the signal below the threshold.
Output
–20dB–+20dB Adjusts the output level of the effect sound.
Attack
0–127 Adjusts the attack of the effect.
Release
0–127 Adjusts the release of the effect.
Hold
0–127 Adjusts the hold time of the effect.
Wet/Dry
100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect
ON/OFF Switches the effect on/off.
Parameter Range Function
Rate
0.1Hz–10.0Hz Adjusts the LFO speed.
Depth
0–127 Adjusts the LFO depth.
FB Invert
ON/OFF Inverts (ON) the phase of the feedback signal.
Feedback
0–127 Adjusts the amount of feedback.
Pan
L63–MID–R63 Adjusts the panning of the effect sound.
Wet/Dry
100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect
ON/OFF Switches the effect on/off.
To Next Page
Loading...
Need help?
General
