Edit page
149
PITCH SHIFTER
This effect modifies the pitch.
REVERB AUDITORIUM
This is a stereo reverb that simulates the reverberation of an auditorium.
Numerous types of reverb are provided. The adjustments are the same as for AUDITORIUM.
REVERB>BIG HALL
Stereo reverb that simulates the reverberation of a large hall.
REVERB>BIG ROOM
Stereo reverb that simulates the reverberation of a spacious room.
REVERB>BRIGHT HALL
Stereo reverb that simulates the reverberation of a bright-sounding hall.
REVERB>DRUM BOOTH
Stereo reverb that simulates the reverberation of a drum booth in a recording studio.
REVERB>LIVE HOUSE
Stereo reverb that simulates the reverberation of a live house (club).
REVERB>MEDIUM HALL
Stereo reverb that simulates the reverberation of a medium-sized hall.
REVERB>MEDIUM ROOM
Stereo reverb that simulates the reverberation of a medium-sized room.
REVERB>PLATE 1
Simulates the reverberation of a conventional plate reverb device.
REVERB>PLATE 2
Simulates the reverberation of a bright-sounding plate reverb device.
REVERB>SMALL HALL
Stereo reverb that simulates the reverberation of a small hall.
REVERB>SMALL ROOM
Stereo reverb that simulates the reverberation of a small room.
REVERB>STUDIO
Stereo reverb that simulates the reverberation of a recording studio.
Parameter Range Function
Left –12.99–+12.99 Adjusts the amount of pitch shift for the L channel.
Feedback 0–127 Adjusts the amount of delay feedback for the L channel.
Right –12.99–+12.99 Adjusts the amount of pitch shift for the R channel.
Feedback 0–127 Adjusts the amount of delay feedback for the R channel.
Wet/Dry 100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect ON/OFF Switches the effect on/off.
Parameter Range Function
Pre-delay 1ms –100ms Adjusts the delay time of the early reflections.
Time 0.1sec –10sec Adjusts the time until the reverberation dies away.
Diffuse 0 –127 Adjusts the density of the reverberation.
HF damp 20Hz –20kHz
Adjusts the frequency at which the high-frequency portion of
the reverberation will be cut.
Near 0 –127 Adjusts the sense of depth.
Width 0 –127 Adjusts the stereo spread.
Wet/Dry 100/0–0/100
Adjusts the balance of the effect sound and dry sound. (With a
setting of 100/0, only the effect sound is output.)
Effect ON/OFF Switches the effect on/off.