Sample mode
166
Trim/Loop page
Trimming or looping a sample
Here you can specify the points at which the sample will begin playing (start point) and
stop playing (end point), switch looping on/off, and specify the points at which looping
will start (loop start point) and end (loop end point) when looping is enabled.
To access this page........[SAMPLE] key → [F2] key (TRIM/LP)
A Sample block
B Trim block
C Waveform display field (upper)
D Loop block
E Waveform display field (lower)
Functions
• [F1] key (LIST)
Displays the Sample mode List page.
• [F3] key (REGION)
Displays the Sample mode Region page.
• [F4] key (Q-FX)
Displays the Quick FX popup window, where you can apply effects to a previ-
ously-recorded sample and resample it.
• [F5] key (EDIT)
Displays the Edit page, where you can edit effects.
• [F6] key (P
®
ALL)
Plays the sample from the beginning, regardless of the start/end/loop point settings. You
can also set these points manually while the sample plays.
Sample block
Here you can select a sample, and specify how to display and monitor it.
A Sample field
Selects the sample that will be edited. When you move the cursor to this field and press
the [WINDOW] key, the Sample popup window will appear.
B Sampling rate/bit field
Indicates the sampling rate and bit depth of the sample you selected in the Sample field.
C View field
Select whether the waveform display will be LEFT (only the left channel), RIGHT (only
the right channel), or MIX (both channels mixed).
1
2
3
4
5
1
3
2
4
To Next Page
Loading...
Need help?
General
