Akai MPC 4000 User Manual

Cable connections
255
Connecting the power cable
1. Insert the connector of the included power cable into the P7 connector or P8
connector of the PC I/O board.
Use the power cable with the ferrite core if you are installing a hard disk. Use the power
cable without a ferrite core if you are installing a Zip drive or CD-ROM drive.
2. Connect the other end of the power cable to the drive.
Connecting the CD-ROM analog audio cable
If the CD-ROM drive has an analog audio output connector, connect it to the MPC4000’s
circuit board as follows.
1. Insert the connector of the included CD-ROM analog audio cable into the P23
connector of the PC I/O ADDA board.
2. Insert the other end of the CD-ROM analog audio cable into the analog audio
output connector of the CD-ROM drive.
Make connections so that the red cable goes to R (right channel) and the white cable to
L (left channel).
3. On the PC I/O ADDA board, plug in the P22 jumper (located in front of P23) at
the “SET” position.
Connecting the CD-ROM digital audio cable
If the IB-4D digital I/O option is installed in the MPC4000, connect the digital audio out-
put connector of the CD-ROM drive to the IB-4D as follows.
1. Insert the connector of the included CD-ROM digital audio cable into the
digital audio output connector of the CD-ROM drive.
Make connections so that the black cable is the ground.
2. Insert the other end of the CD-ROM digital audio cable into the P1 connector
of the IB-4D digital I/O option.
3. On the IB-4D circuit board, plug in the JP1 jumper in the 1-2 (SHORT) position.
* If you connect the analog/digital audio cable and make the correct jumper setting, you
will be able to select the CD-ROM playback as the recording source in RECORD mode.
Master/slave settings for ATA drives
If you install two drives, you must set one as the master and the other as the slave. (If a
hard disk is installed, set the hard disk as the master.)
For details on how to make master/slave settings, refer to the manual that came with your
drive.

Akai MPC 4000 Specifications

General

Polyphony	64 voices
RAM	272 MB (expandable to 512 MB)
Pads	16 velocity and pressure-sensitive pads
MIDI	2 MIDI inputs, 4 MIDI outputs
Sampling Frequency	44.1 kHz
Display	240x64 backlit LCD
Effects	4 internal effects processors
Storage	Internal Hard Drive
Sequencer	300, 000 notes capacity
Filter	Multi-mode filter (Low Pass, High Pass, Band Pass, Band Boost, Band Reject)