Akai MPC 4000 User Manual

Sequence edit mode
50
• Control number field
Selects the control change number.
• Value (Start value) field
Specifies the value of the control change events that will be inserted. If you have spec-
ified a region, this specifies the value of the control change that will be inserted at the
starting point.
• End value field
Specifies the value that will be inserted at the ending point. (Displayed only if you
specified a region.)
• Interval field
Selects the spacing of the control change events that will be inserted. (Displayed only
if you specified a region.)
• Curve field
Selects the curve by which the control change values will change. (Displayed only if
you specified a region.)
• Graph display
Displays a curve showing the control change values that will be inserted. (Displayed
only if you specified a region.)
CH PRESSURE
• Time field
Indicates the location at which the data will be inserted. The left side of the Time field
shows the starting location of the inserted events, and the right side shows the ending
location.
• Value (Start value) field
Specifies the value of the channel pressure events that will be inserted. If you have
specified a region, this specifies the channel pressure value that will be inserted at the
starting point.
• End value field
Specifies the value that will be inserted at the ending point. (Displayed only if you
specified a region.)
• Interval field
Selects the spacing of the channel pressure events that will be inserted. (Displayed
only if you specified a region.)
• Curve field
Selects the curve by which the channel pressure values will change. (Displayed only
if you specified a region.)
• Graph display
Displays a curve showing the channel pressure values that will be inserted. (Dis-
played only if you specified a region.)
POLY PRESSURE
• Time field
Indicates the location at which the data will be inserted. The left side of the Time field
shows the starting location of the inserted events, and the right side shows the ending
location.
• Note field
Selects the polyphonic key pressure note number.
• Value (Start value) field
Specifies the value of the polyphonic key pressure events that will be inserted. If you
have specified a region, this specifies the polyphonic key pressure value that will be
inserted at the starting point.
• End value field
Specifies the value that will be inserted at the ending point. (Displayed only if you
specified a region.)

Akai MPC 4000 Specifications

General

Polyphony	64 voices
RAM	272 MB (expandable to 512 MB)
Pads	16 velocity and pressure-sensitive pads
MIDI	2 MIDI inputs, 4 MIDI outputs
Sampling Frequency	44.1 kHz
Display	240x64 backlit LCD
Effects	4 internal effects processors
Storage	Internal Hard Drive
Sequencer	300, 000 notes capacity
Filter	Multi-mode filter (Low Pass, High Pass, Band Pass, Band Boost, Band Reject)