Akai MPC 4000 User Manual

Step edit mode
60
PITCH BEND............................. Pitch bend
CONTROL CHANGE ................ Control change
PROGRAM Change.................... Program change
CH PRESSURE.......................... Channel key pressure
POLY PRESSURE...................... Polyphonic key pressure
The fields that are displayed will depend on the event you selected.
PITCH BEND
• Time field
Indicates the location at which the data will be inserted. If you are inserting multiple
events in a single operation, the left side of the Time field shows the starting location
of the inserted events, and the right side shows the ending location.
• Value (Start value) field
Specifies the value of the pitch bend events that will be inserted. If you have specified
a region, this specifies the pitch bend value that will be inserted at the starting point.
• End value field
Specifies the value that will be inserted at the ending point. (Displayed only if you
specified a region.)
• Interval field
Selects the spacing of the pitch bend events that will be inserted. (Displayed only if
you specified a region.)
• Curve field
Selects either LINEAR, LOGARITHM, or EXPONENTIAL as the curve by which
the pitch bend values will change. (Displayed only if you specified a region.)
• Graph display
Displays a curve showing the pitch bend values that will be inserted. (Displayed only
if you specified a region.)
CONTROL CHANGE
• Time field
Indicates the location at which the data will be inserted. If you are inserting multiple
events in a single operation, the left side of the Time field shows the starting location
of the inserted events, and the right side shows the ending location.
• Control number field
Selects the control change number.
• Value (Start value) field
Specifies the value of the control change events that will be inserted. If you have spec-
ified a region, this specifies the value of the control change that will be inserted at the
starting point.
• End value field
Specifies the value that will be inserted at the ending point. (Displayed only if you
specified a region.)
• Interval field
Selects the spacing of the control change events that will be inserted. (Displayed only
if you specified a region.)
• Curve field
Selects the curve by which the control change values will change. (Displayed only if
you specified a region.)
• Graph display
Displays a curve showing the control change values that will be inserted. (Displayed
only if you specified a region.)
PROGRAM CHANGE
• Time field
Indicates the location at which the data will be inserted.

Akai MPC 4000 Specifications

General

Polyphony	64 voices
RAM	272 MB (expandable to 512 MB)
Pads	16 velocity and pressure-sensitive pads
MIDI	2 MIDI inputs, 4 MIDI outputs
Sampling Frequency	44.1 kHz
Display	240x64 backlit LCD
Effects	4 internal effects processors
Storage	Internal Hard Drive
Sequencer	300, 000 notes capacity
Filter	Multi-mode filter (Low Pass, High Pass, Band Pass, Band Boost, Band Reject)