Alfa Laval S 821 - Lowering Spindle Assembly into Frame

6.5 ASSEMBLY 6 SERVICE, DISMANTLING, ASSEMBLY
104
11 Lowering the spindle assembly into the frame.
G0867971
b Position the flat belt so
that the spindle assembly can
pass through when lowering.
See note below.
o
c Carefully lower the spindle assembly and position
the bolt holes over the threaded frame holes.
Make sure that the bottom bearing, enters the
bottom bearing holder correctly. Do not use force.
W
A
R
N
I
N
G
!
Cut hazard
Do not put fingers between the frame and air
deflector while lowering the assembly.
d Fit and tighten the screws.
a Remove the cap nut from the spindle.
Fit the lifting tool to the spindle assembly and lift it.
W
A
R
N
I
N
G
!
Crush hazard
Do not rotate the spindle assembly during lifting. The spindle
assembly may otherwise come loose from the lifting tool.
N
O
T
E
Check that the hole at the bottom of the oil pump is clean before
lowering the assembly down.
N
O
T
E
Check the direction arrows on the belt and the
machine plate for correct position.
Make sure that the belt does not get smudged
with oil or grease during handling.
e Tighten the plugs firmly.
Check the bottom hole.
Space