6.3 DISMANTLING 6 SERVICE, DISMANTLING, ASSEMBLY
46
6.3 Dismantling
6.3.1 Introduction
The frame hood and heavy bowl parts must
be lifted by means of a hoist. Position the
hoist exactly above the bowl centre. Use a
lifting sling and lifting hooks with safety
catches.
The parts must be handled carefully. Don’t
place parts directly on the floor, but on a
clean rubber mat, fibreboard or a suitable
pallet.
N
O
T
E
For safety reasons, it is essential that all personnel
who work with the separator read this manual
thoroughly and completely.
Do not allow personnel to clean, assemble, operate
or maintain the separator until they have read and
fully understood this manual.
Ensure that all personnel who operate and service
the separator are well-trained and knowledgeable
concerning the separator and the work to be
carried out.
6.3.2 Tools
Special tools from the tool kit must be used
for dismantling and assembly, as well as
Standard tools (not included). The special
tools are specified in the Spare Parts Catalogue
and are illustrated at the beginning of each
dismantling section.
W
A
R
N
I
N
G
!
Entrapment hazard
To avoid accidental start, switch off and lock-out
power supply before starting any dismantling work.
Make sure that machine has come to a complete
standstill before starting any dismantling work
(takes about 22 minutes from switch off).
To Next Page
Loading...
