119
6 SERVICE, DISMANTLING, ASSEMBLY 6.5 ASSEMBLY
14 Fitting the bowl hood.
G0862481
a Apply a thin layer of silicone grease and fit the
O-ring
i
o
b Fit the seal ring Press
the ring down evenly until bulges
appear.
i
o
d Fit the compressing tool and attach
lifting eyes. Lower the bowl hood so that
its recess fits into the guide pin in the
bowl body.
Recess on bowl hood
Guide pin on bowl body
c Carefully tap down the bulges crosswise with a soft
rubber mallet, until the ring is completely fitted.
e Remove the compressing tool.
To Next Page
Loading...
