29
5 Operating Instructions
These operating instructions describe
routine procedures to follow before and
during the start, running and stopping
sequences of the separator.
If system documentation is available,
always follow the operating instructions
therein. If there is no system
documentation, the instructions below are
to be followed.
5.1 Before First Start-up
Technical demands for connections and
limitations for the separator are listed in
chapter
8 Technical Reference, page 147:
• Technical data
• Connection list
• Interface description
• Basic size drawing
• Foundation drawing.
Before first start:
• Ensure the machine is installed and
assembled correctly and that feed lines and
drains have been flushed clean.
• Fill oil in the oil bath. See 6.7 Oil Change,
page 131.Quality of oil see 6.7.6
Lubricating oils, page 138.
• Make sure that the bearings on the spindle
are pre-lubricated.
• Check the direction of rotation by doing a
quick start/stop. The motor fan should
rotate clockwise.
G0868741
To Next Page
Loading...
