Alfa Laval S 821 - Storage Out of Operation; Before Start-up (After Storage)

173
9 INSTALLATION 9.4 STORAGE AT OUT OF OPERATION
9.4 Storage at out of
operation
If the separator is out of operation for more
than 1 month:
1 Lift out the bowl.
2 Protect the spindle taper from corrosion by
lubricating it with oil.
3 Keep the separator and bowl well stored, dry
and protected from mechanical damage.
For details see 9.2.2 Protection and storage of
gods, page 169
9.5 Before start-up
If the separator has been out of operation for:
1 months or longer
• Pre-lubricate the spindle bearings.
6 months or longer
• Perform an Inspection service and make
sure to pre-lubricate the spindle bearings.
• Change the oil before starting.
18 months or longer
• Perform an Overhaul service and make
sure to pre-lubricate the spindle bearings.
• Change the oil before starting.
i
i
o
G0868741