6.7 OIL CHANGE 6 SERVICE, DISMANTLING, ASSEMBLY
132
6.7.2 Check oil level
1 Remove the oil pin and make sure that the oil
level is above the lower end of the pin.
6.7.3 Oil change procedure
1 Remove the oil pin, plug and washer.
2 Place a vessel under the drain plug.
3 Remove the drain plug.
4 Collect the oil in a vessel.
5 Fit and tighten the drain plug.
6 Fill with new oil until oil flows out of oil filler
hole.
7 Fit the washer and the oil filling plug. Tighten
the plug.
8 Fit the oil pin.
C
A
U
T
I
O
N
!
Burn hazard
The lubricating oil and various machine surfaces can
be sufficiently hot to cause burns.
N
O
T
E
See 6.7.6 Lubricating oils, page 138.
G08687H1
Oil fill
Oil drain plug
Plug and washer
N
O
T
E
For Inspection service procedures; See
“Fill oil in the oil sump.” on page 108.
Max.
Min.
To Next Page
Loading...
