6.5 ASSEMBLY 6 SERVICE, DISMANTLING, ASSEMBLY
108
16 Fitting the clutch cover.
17 Fill oil in the oil sump.
G0858141
a Fit the clutch cover.
b Tighten the screws.
G08687G1
c Fill with new oil until oil flows out from
the filler hole.
For correct oil volume see
‘‘Lubricating oil volume” on page 148.
N
O
T
E
For grade and quality of oil see
6.7.6 Lubricating oils, page 138
N
O
T
E
The separator should be level and at
standstill when oil is filled.
a Remove the oil pin, plug and washer.
f Fit the oil pin.
b Fit new washer and refit the drain
plug.
i
d Fit new O-ring onto the oil pin.
i
e Refit the plug with new washer
i
To Next Page
Loading...
