6.4 ACTIONS BEFORE ASSEMBLY 6 SERVICE, DISMANTLING, ASSEMBLY
80
6.4 Actions Before
Assembly
6.4.1 Cleaning
Clean the separator parts according to the
diagram below. Afterwards, protect all cleaned
carbon steel parts against corrosion by oiling.
Part Procedure Cleaning agents
Frame and
motor
The external cleaning of the frame and motor should be
restricted to brushing, sponging or wiping while the motor is
running or still is hot.
Clean the inside of the frame with a clean cloth and remove
visible particles.
Water and de-greasing agent.
i o
W
A
R
N
I
N
G
!
Electrical hazard
Never wash down a separator with a direct water
stream.
Never play a water jet on the motor. Totally
enclosed motors can be damaged by direct hosing
to the same extent as open motors, resulting in
short-circuit and internal corrosion.
To Next Page
Loading...
