87
6 SERVICE, DISMANTLING, ASSEMBLY 6.4 ACTIONS BEFORE ASSEMBLY
6.4.7 How to lubricate bowl parts
with slide laquer
G0874861
a Carefully clean the contact surfaces (1) on bowl body
and bowl hood.
1
b Apply Molykote D321R on surfaces.
c Air-cure for 15 minutes.
d Use a smooth fibre brush to polish to an even and
homogenous contact film.
e Apply a second layer slide laquer.
f Air-cure for 15 minutes.
g Polish the film to a shiny surface, the film should look
like well-polished leather when properly done.
h Finish the treatment by lubricating the contact surfaces
with Alfa Laval lubricating paste or Molykote 1000
paste. Use a well cleaned brush and rub it into the
surface, do not leave any excessive paste.
1
1
N
O
T
E
This instruction is also valid for
the operating slide and the holder.
To Next Page
Loading...
