Allied Telesis AT-9724TS Reference Manual

disable shh
Purpose Used to enable SSH.
Syntax disable ssh
Description This command allows you to disable SSH on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable SSH:
AT-9724TS:4# disable ssh
Command: disable ssh
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
config shh authmode
Purpose Used to configure the SSH authentication mode setting.
Syntax config ssh authmode [password | publickey | hostbased] [enable | disable]
Description This command will allow you to configure the SSH authentication mode for users attempting to access the
Switch.
Parameters password – This parameter may be chosen if the administrator wishes to use a locally configured password for
authentication on the Switch.
publickey - This parameter may be chosen if the administrator wishes to use a publickey configuration set on a
SSH server, for authentication.
hostbased - This parameter may be chosen if the administrator wishes to use a host computer for
authentication.This parameter is intended for Linux users requiring SSH authentication techniques and the host
computer is running the Linux operating system with a SSH program previously installed.
[enable | disable] - This allows you to enable or disable SSH authentication on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable the SSH authentication mode by password:
AT-9724TS:4# config ssh authmode password enable
Command: config ssh authmode password enable
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
155
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g