Allied Telesis AT-9724TS Reference Manual

show shh authmode
Purpose Used to display the SSH authentication mode setting.
Syntax show ssh authmode
Description This command will allow you to display the current SSH authentication set on the Switch.
Parameters None.
Restrictions None.
Example usage:
To view the current authentication mode set on the Switch:
AT-9724TS:4# show ssh authmode
Command: show ssh authmode
The SSH User Authentication Support
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
P a s s w o r d : E n a b l e d
P u b l i c k e y : E n a b l e d
H o s t b a s e d : E n a b l e d
A T - 9 7 2 4 T S : 4 #
config shh server
Purpose Used to configure the SSH server.
Syntax config ssh server {maxsession <int 1-3> | contimeout <sec 120-600> | authfail <int 2-20>
| rekey [10min | 30min | 60min | never] | port <tcp_port_number 1-65535>}
Description This command allows you to configure the SSH server.
Parameters maxsession <int 1-3> – Allows the user to set the number of users that may simultaneously access the Switch.
The default is 3.
contimeout <sec 120-600> – Allows the user to set the connection timeout.The user may set a time between
120 and 600 seconds.The default is 120 seconds.
rekey [10min | 30min | 60min | never] – Sets the time period that the Switch will change the security shell
encryptions.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the SSH server:
AT-9724TS:4# config ssh server maxsession 2 timeout 300
authfail 2
Command: config ssh server maxsession 2 timeout 300
authfail 2
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
156
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g