Allied Telesis AT-9724TS Reference Manual

reset
Purpose Used to reset the Switch to the factory default settings.
Syntax reset {[config | system]}
Description This command is used to restore the Switch’s configuration to the default settings
assigned from the factory.
Parameters config – If the keyword ‘config’ is specified, all of the factory default settings are restored on the Switch including
the IP address, user accounts, and the Switch history log.The Switch will not save or reboot.
system – If the keyword ‘system’ is specified all of the factory default settings are restored on the Switch.The
Switch will save and reboot after the settings are changed to default. Rebooting will clear all entries in the
Forwarding Data Base.
If no parameter is specified, the Switch’s current IP address, user accounts, and the Switch history log are not
changed.All other parameters are restored to the factory default settings.The Switch will not save or reboot.
Restrictions Only administrator-level users can issue this command.
Example usage:
To restore all of the Switch’s parameters to their default values:
AT-9724TS:4# reset config
Command:reset config
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
login
Purpose Used to log in a user to the Switch’s console.
Syntax login
Description This command is used to initiate the login procedure.The user will be prompted for his Username and
Password.
Parameters None.
Restrictions None.
Example usage:
To initiate the login procedure:
AT-9724TS:4# login
C o m m a n d : l o g i n
U s e r N a m e :
A T - 9 7 2 4 T S : 4 #
26
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g