Allied Telesis AT-9724TS Reference Manual

config route preference
Purpose Used to configure the route preference of each route type.
Syntax config route preference [static | rip | ospfIntra | ospfInter | ospfExt1 | ospfExt2] <value 1-
999>
Description This command is used to set the route preference value for each routing protocol listed.A lower value will
denote a better chance that the specified protocol is the best path for routing packets.
Parameters The user may set a preference value for a specific route by first choosing one of the following and then adding
an alternate preference value:
static – Choose this parameter if you wish to configure the preference value for the static route.
rip – Choose this parameter if you wish to configure the preference value for the RIP route.
ospfIntra – Choose this parameter if you wish to configure the preference value for the OSPF
Intra-area route.
ospfInter – Choose this parameter if you wish to configure the preference value for the OSPF
Inter-area route.
ospfExtT1 – Choose this parameter if you wish to configure the preference value for the
OSPF AS External route type-1.
ospfExtT2 – Choose this parameter if you wish to configure the preference value for the
AS External route type-2 route.
<value 1-999> – Enter a value between 1 and 999 to set the route preference for a particular route.The lower
the value, the higher the chance the specified protocol will be chosen as the best path for routing packets.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the route preference value for RIP as 50:
AT-9724TS:4# config route preference rip 50
Command: config route preference rip 50
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
269
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g