To Next Page

To Previous Page

8 Parameter detail setup

8.2.9 Alarm□ Alarm No(Alarm□ output alarm number)

Select alarm output number to output alarm in alarm ON.

If the setting as ‘None’ and when alarm operation occurs, it displays alarm on the screen and

records alarm operation mode, and alarm occurrence time on recording paper, but it does not

output alarm.

There are two alarm output types; Transistor and Relay output. KRN recognizes automatically

the connected type and displays it.

In this parameter, transistor output type is displayed as TR-S□AL-□(□), and Relay output type

is displayed as RELAY-S□AL-□(□).

These parameter’s meaning is as below.

S□: The number of module connected SLOT,

AL-□: Alarm output channel number,

Number in parenthesis ‘(□)’: the number of designated alarm as output in the specified channel

 Setting range: None / □-S□AO-□(□)

 Factory default: None

8.2.10 Select Alarm Card(Select alarm output card)

Select alarm output card(KRN-AR4, KRN-AT6) to set output type (Normally Open, Normally

Closed) of alarm output. In front of output card name, relay or transistor abbreviation is displayed

for easy to know connected module type when selecting output card.

Autonics krn100 series User Manual

Other manuals for Autonics krn100 series