Autonics krn100 series User Manual

8 Parameter detail setup
106 © Copyright Reserved Autonics Co., Ltd.
8.5.10 Alarm Speed (Alarm record speed)
Set record speed for alarm cause and details when alarm occurs.
It is actiaved when Record Mode(Record mode) is set as Graph.
You cannot set Alarm Speed(Alarm record speed) as below Standard Speed(Standard record
speed). If you change Standard Speed, Alarm Speed is changed as the same set value
automatically.
When alarm occurs, record progresses with set Alarm Speed. When alarm is reset, it returns to
Standard Speed.
 Setting range: 10↔20↔40↔60↔120↔240mm/h
 Factory default: 20mm/h
 If alarm and digital input occur at the same time, digital input is ignored and it records with
the set value of Alarm Speed(Alarm record speed). When alarm is reset, it returns to
Standard Speed (Standard record speed).
In graph mode, record speed is change by Standard speed, Alarm and Option Speed.
Backup data is printable only with Standard speed. Therefore, original graph mode printout
and backup graph mode printout may be different.
8.5.11 Power On Status (Record status when power ON)
Designate one record operation stauts from 3 mode for when KRN100 re-turns ON from OFF by
power failure.
Hold(Maintain) Maintains record status of before power OFF (recording or stop
recording).
Run(Record) Operates recording when power is ON.
Stop(Stop recording) No recording when power is ON.
 Setting range: Hold↔Run↔Stop
 Factory default: Hold

Autonics krn100 series Specifications

General

Brand	Autonics
Model	krn100 series
Category	Measuring Instruments
Language	English