Autonics krn100 series User Manual

8 Parameter detail setup
© Copyright Reserved Autonics Co., Ltd. 93
8.4.10 Ethernet Port (Use Ethernet communication)
Set whether using Ethernet communication.
If you set Ethernet Port as ‘Enable’, RS485 Port is changed as ‘Disable’ automatically.
 Setting range: Enable ↔ Disable
 Factory default: Disable
You can monitor or set parameter KRN100 with DAQMaster or the related Modbus program
(Modbus Poll, etc). For more information, refer to ‘KRN100 user manual for communication.’
[Modbus TCP communication]
The following is based on Windows X P.
First of all connect Ethernet slot of KRN-100 communication output card (KRN-COM)
and LAN slot of PC with LAN cable.
Execute Start > Run to check IP address of PC.

Autonics krn100 series Specifications

General

Brand	Autonics
Model	krn100 series
Category	Measuring Instruments
Language	English