Autonics krn100 series - Parity Bit (Communication Parity Bit); Stop Bit(Communication Stop Bit); Termination Set (Terminating Resistance)

8 Parameter detail setup
© Copyright Reserved Autonics Co., Ltd. 91
8.4.4 Parity Bit (Communication parity bit)
Designate communication parity bit.
 Setting range: None ↔ Odd ↔ Even
 Factory default: None
8.4.5 Stop Bit(Communication stop bit)
Designate communication stop bit.
 Setting range: 1 ↔ 2 (unit: bps)
 Factory default: 2
8.4.6 Termination Set (Terminating resistance)
Desigante wheter using terminating resistance .
You do not need to external terminating resistance (120Ω) because KRN100 is enable to use
terminating resistance by parameter setting.
 Setting range: Enable ↔ Disable
 Factory default: Disable