Safety Considerations
© Copyright Reserved Autonics Co., Ltd. v
Safety Considerations
Please observe all safety considerations for safe and proper product operation to avoid
hazards.
Safety considerations are categorized as follows.
Warning
Failure to follow these instructions may result in serious
injury or death.
Caution
Failure to follow these instructions may result in personal
injury or product damage.
Fail-safe device must be installed when using the unit with machinery that may cause serious injury
or substantial economic loss. (e.g. nuclear power control, medical equipment, ships, vehicles,
railways, aircraft, combustion apparatus, safety equipment, crime/disaster prevention devices, etc.)
Failure to follow this instruction may result in personal injury, economic loss or fire.
Do not connect, repair, or inspect the unit while connected to a power source.
Failure to follow this instruction may result in fire or electric shock.
Check ‘Connections’ before wiring.
Failure to follow this instruction may result in fire.
Do not touch the product during operation or for a certain period of time after stopping.
Failure to follow this instruction may result in burn or fire.
Do not use the unit in the place where flammable/explosive/corrosive gas, high humidity, direct
sunlight, radiant heat, vibration, impact, or salinity may be present.
Failure to follow this instruction may result in explosion or fire.
Install on the device panel or DIN rail, and ground to the F.G. terminal separately.
When connecting the F.G. terminal, use AWG16(1.25mm
2
) or over.
Failure to follow this instruction may result in fire or electric shock.
Do not disassemble or modify the unit.
Failure to follow this instruction may result in fire or electric shock.
Since Lithium battery is embedded in the product, do not disassemble or burn the unit.
Failure to follow this instruction may result in fire.
.
To Next Page
Loading...
Need help?
General
