Safety Considerations
vi © Copyright Reserved Autonics Co., Ltd.
Use the unit within the rated specifications.
Failure to follow this instruction may result in fire or product damage.
Use a dry cloth to clean the unit, and do not use water or organic solvent.
Failure to follow this instruction may result in fire or electric shock.
Keep the product away from metal chip, dust, and wire residue which flow into the unit.
Failure to follow this instruction may result in fire or product damage.
When connecting the power input or measurement input, use AWG20(0.50mm²) cable or over and
tighten the terminal screw with a tightening torque of 0.74 to 0.9N
·
m.
Failure to follow this instruction may result in fire or malfunction due to contact failure.
Do not use the load beyond rated switching capacity contact.
Failure to follow this instruction may result in fire, relay broken, contact melt, insulation failure or
contact failure.
Do not disassemble or assemble input/output card, when power is supplied.
Failure to follow this instruction may result in product damage.
Use the transmitter output terminals only as the power for the transmitter.
Failure to follow this instruction may result in product damage.
When connecting the temperature sensor(TC, RTD) or analogue input (voltage, current) as input to
the universal input card, set the jumper pin to the correct place for the connected input method.
If the jumper pin is placed improperly, it may result in product damage or malfunction.
※
The specifications and dimensions of this manual are subject to change without notice.
※
Be sure to follow cautions written in the instruction manual and the technical descriptions
(catalog, website).
To Next Page
Loading...
Need help?
General
