5 Installation
© Copyright Reserved Autonics Co., Ltd. 29
5 Installation
5.1 Installation place
Install this unit in place where the below conditions are satisfied.
Place where ventilation is well
To prevent from malfunction and damage by overheating (use temperature range: 0 to
50℃), install this unit where ventilation is well.
In case installing several KRN100, space each other by panel cut-out.
Place where vibration is not severe
If there is too much vibration, it may cause malfunction such as print error.
For more information about vibration, please refer to ‘2 Specification’.
In case of temperature measurement with thermocouple temperature sensor at the place
where temperature is fluctuated, data error may occur. You should warm-up this unit over
30 min. to acquire accurate data before using it.
At the place where temperature and humidity is fluctuated excessively, recording paper
color may be changed.
To Next Page
Loading...
