Autonics krn100 series - Filter Counter (the Number of Digital Filter)

8 Parameter detail setup
70 © Copyright Reserved Autonics Co., Ltd.
8.1.18 Filter Counter (The number of digital filter)
Designate the number of sampling which apply to digital filter.
When you set Filter Type(Input digital filter), this parameter is activated.
 Setting range: 1 to 128
 Factory default: -
When the set value of input digital filter is ‘4’, it does moving average input sampling values for
0.1 sec (100ms) and displays this value.
D1=S1
D2 =
S1 + S2
2
, D3 =
S1 + S2 + S3
3
Display values of D1, D2, D3 is the initial operation before averaging 4 sampling values.
D4 =
S1 + S2 + S3 + S4
4
, D5 =
S2 + S3 + S4 + S5
4
D6 =
S3 + S4 + S5 + S6
4
, D7 =
S4 + S5 + S6 + S7
4
D8 =
S5 + S6 + S7 + S8
4