Shaping
Configuring CBQ fails on a Class-map
Symptom: An Error message will be thrown when CBQ is configured at policy-map level.
Problem description: Configuring CBQ parameters should adhere to the following conditions:
1.
Sum of all leaf classes should not exceed 99 percent.
2. Parent-class should be configured with a valid Peak Rate that is greater than or
equal to the requested Committed Rate of the child class.
3. Sum of CR of child classes to a parent class should not exceed the Parent class
Peak rate.
4. Peak rate of child class should not exceed Parent class Peak rate.
Prerequisite: Policy-map should be successfully created
Chassis QoS troubleshooting
Troubleshooting August 2013 251
To Next Page
Loading...
