30
Choose a camera to congure.
Selected the desired built-in IR cut lter mode to ensure the
camera works properly both in the day and night.
Set the delay time of IR-CUT switching.
To enable or disable Backlight compensation.
Set the 3D noise reduction level.
Set the WDR level.
Congure white balance.
Set the shutter mode.
Choose the exposure time of the camera.
Use in foggy environments to improve the video quality.
Flip vertical
Flip horizontal
Set the IR LED / Supplement lights on/o
To enable the corridor mode
To enable or disable the high light compensation
Set the IR LED level
IR-CUT Mode: If you want the camera to switch the image between colorful and black & white automati-
cally, then choose “GPIO Auto”; If you want the camera to record colorful images all the time, then choose
“Color Mode” ; If you want the camera to record black & white images all the time, then choose “Black
White Mode”; If you want the camera to record black & white images in a certain period, then choose
“Schedule(B/W)”, and then set the start and end time.
WDR/DWDR: Enable to allow automatically adjust the brightness and contrast of the video when shooting
in the darkness with bright light sources.
IR-LED / Supplement Light: Set the IR/Supplement lights on/o.
5 NVR System Setup
To Next Page
Loading...
