Please carefully read the following safety instructions so as to avoid personal injuries and prevent the
equipment and other connected devices from being damaged.
1. Power sources (note: please use the power supply attached or specied by the manufacturer.)
Never operate the equipment by using an unspecied power supply.
2. Never push objects of any kind through the openings of the NVR
Never push objects of any kind through the openings of the NVR to avoid electric shock or any
other accidents.
3. Do not put the equipment in a dusty area.
4. Do not place the equipment in rain or humid environments.
Do not place the equipment under humid environment (e.g basement). If the equipment makes con-
tact with water, please unplug the power cable and immediately contact your local dealer.
5. Keep the surface of the equipment clean and dry.
Use a soft damp cloth to clean the outer case of the NVR (do not use liquid aerosol cleaners)
6. Do not operate if any problems are found.
If there are any strange smells or sounds coming from the NVR, unplug the power cable and contact
the authorized dealer or service center.
7. Do not try to remove the upper cover.
Warning: Do not remove the cap of the NVR to avoid electric shock.
8. Handle with care. If the
NVR does not properly function because of any hard impacts to the device, please contact the
authorized dealer for repairs or a replacement.
9. Use the standard lithium battery (Note: Use the batteries attached or specied by
the manufacturer).
After cutting o the power supply, if the system clock does not continue to work, please replace the
standard 3V lithium battery on the main board.
Warning: Turn o the NVR before replacing the batteries, or you may suer from a serious
electric shock. Please properly dispose of the used batteries.
10. Put the equipment in a place with proper ventilation.
The NVR system includes an HDD, which produces a large amount of heat during operation. As a result,
do not block any ventilation openings (on the top, bottom, both sides and the reverse side) for cooling
the system during operation. Install or put the equipment in a place with proper ventilation.
11. The attached power adapter can only be used for 1 set of NVR, Do not connect more equipment, or
the NVR may restart repeatedly due to insucient power.
12. Prevent the equipment from getting into contact with water or any form of splashing. Do not place
objects containing water on the equipment (e.g ower vase lled with water).
SAFETY INSTRUCTIONS
Safety Instructions
To Next Page
Loading...
