76
5 NVR System Setup
Congure the pedestrian and vehicle alarm function
Camera: Camera name
Buzzer: NVR/DVR internal buzzer. You can set the buzzer duration time (in seconds) for triggering a pedes-
trian and vehicle alarm.
Alarm out: Check the external alarm device when the pedestrian and vehicle alarm is triggered.
Delay: Set the duration of triggering the external alert devices (10s, 20s, 40s, and 1Min).
Record: Click icon to set channels that pedestrian and vehicle alarms.
Duration: set the duration of continuous NVR/DVR recording after the event occurs. The suggested record-
ing time is 30 seconds, but can be set to up to 5 minutes.
Show Message: Select this box to show icon when pedestrian and vehicle alarms are detected.
Send Email: DVR send an automatic email when pedestrian and vehicle alarms are detected.
FTP Picture Upload: To upload alarm images to FTP server when an alarm is triggered. To enable FTP,
please view 5.4.4 FTP.
FTP Video Upload: To upload alarm video to FTP server when an alarm is triggered. To enable FTP, please
view 5.4.4 FTP.
Picture to Cloud: To upload alarm images to Cloud server when an alarm is triggered. To enable Cloud,
please view 5.5.2 Cloud.
Video to Cloud: To upload alarm video to Cloud server when an alarm is triggered. To enable Cloud,
please view 5.5.2 Cloud.
Full Screen: If this feature is enabled and the pedestrian and vehicle alarms are detected in the channel,
you will see the channel in full-screen mode.
Voice Prompts: Voice prompt, when the alarm is triggered, the audio le is imported by the voice prompt
(the IPC needs to support the voice prompt function), Please view in 5.3.7 Voice Prompts
To Next Page
Loading...
