Baker Hughes Apollo 3 - Change the Passwords; Set the Date and Time; Set the Drive Mode; Set the Motor Overload

Copyright 2020 Baker Hughes Company. All rights reserved.
Page 22 of 277
2.4 Set the Date and Time
See Section 4.4.1 Set Date/Time, page 92.
2.5 Change the Passwords
Best practice is to change the passwords from the defaults to protect the system configuration from
unauthorized changes. From the Main Menu, select Other Initial Setup and then Setup Password
Protections. Set values for the Level 2 and Advanced passwords as desired.
2.6 Set the Pump Direction
The Pump Direction setting is available in the “Logged In” settings rotation and in the Config Drive Settings
menu. To access in the settings rotation, from the Home Screen repeatedly press the Settings function
button. If a window appears asking you to log in, log in and then continue to press the Settings function
button until the Forward/Reverse parameter is shown. Set the direction as desired and press the Save
function button. Confirm the change.
To access from the Config Drive Settings menu, from the Main Menu select the Config Drive Settings option.
Select Forward/Reverse and change the setting as described above.
See Section 4.5 Configure Drive Settings, page 104 for more information.
2.7 Set the Well Name/Site Name
See Section 4.4.2 Set Well and Site Names, page 93.
2.8 Set the Motor Overload
See Section 4.7 Configure Motor Overload, page 111 for additional details.
The Motor Overload limit is also available in settings rotation if you are logged in. To access in the settings
rotation, from the Home Screen repeatedly press the Settings function button. If a window appears asking
you to log in, log in and then continue to press the Settings function button until the Motor Overload
parameter is shown. Set the limit as desired and press the Save function button. Confirm the change.
2.9 Set the Motor Underload
See Section 4.8 Configure Motor Underload, page 114 for additional details.
The Motor Underload limit is also available in the “Logged In” settings rotation. To access in the settings
rotation, from the Home Screen repeatedly press the Settings function button. If a window appears asking
you to log in, log in and then continue to press the Settings function button until the Motor Underload
parameter is shown. Set the limit as desired and press the Save function button. Confirm the change.
2.10 Set the Drive Mode
See Section 5.6 Setup Drive Mode, page 139 for additional details.